|
| Adjustable
Features: |
- Two
smooth, accurate rev limits are adjustable in 100 rpm increments
with rotary dials - no modules!
- Single
stage retard for top end speed or nitrous systems.
- Adjustable
magnetic pickup compensation for trigger accuracy.
- Start
retard eases cranking pressure on high com- pression, engines.
|
PN 7520 Digital 7 Plus
|

Digital
7 Plus Ignition Control,
PN 7520
For
drag racers, the MSD 7AL-2 has long been the standard ignition due
to its reliability and power. By combining the 7AL-2's high performance
with the proven digital technology from the Digital-6 Plus Ignition,
MSD once again raised the performance ignition standards by introducing
the Digital-7 Plus Ignition Control. State-of-the-art technology allows
the 7 Plus to produce more power while using the same amount of current.
The CD circuits combined with an IGBT Coil driver deliver 520 - 535
volts to the primary side of the coil with up to 190 millijoules of
energy at any rpm. Below 3,300 there is of course MSD's powerful series
of multiple sparks, rather than a single spark. This spark series burns
in the cylinder for over 20° of crankshaft rotation resulting in improved
combustion and increased power. Inside the familiar gold housing is
a 15 Megahertz microcontroller, the fastest of any digital ignitions.
This means that the controller analyzes up to 15,000,000 critical
instructions per second to produce the most accurate timing control
and rev limits possible! There are two smooth rev limits, one for
top end overrev protection and another for a launch rpm. For nitrous
applications or for racers looking for a little more mph, there is
a high speed retard circuit that is adjustable up to 9.9°. These features
are adjustable with rotary dials plus there is a diagnostic LED. The
Digital-7 Plus can be used on 4, 6 or 8-cylinder engines and should
be used with an MSD HVC Coil (PN
8251 or PN 8261).
MSD
Digital-7 Plus Ignition Control,
PN 7520* 
|
OPERATING
SPECIFICATIONS
|
| Spark
Energy: |
190
MilliJoules Per Spark |
| Primary
Voltage: |
535
Volts |
| Output
Voltage: |
40,000
Volts |
| Operating
Voltage: |
12-18
Volts, Neg. Ground |
| Current
Draw: |
1.1
Amp per 1,000 rpm |
| RPM
Range: |
12,500
rpm with 14.4 Volt Supply |
| Weight
& Size: |
3.7lbs.,
8.5"L x 4.5"W x 2.2"H |
| Tested
with the Pro Power HVC Coil, PN 8251 |
*Not
legal for sale or use on emission controlled vehicles. |