MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Ignition Forums > Trouble-Shooting

Trouble-Shooting Diagnose your ignition

Reply
 
Thread Tools
  #1  
Old 08-09-2003, 04:11 PM
1971mustangconvertible302 1971mustangconvertible302 is offline
Junior Member
 
Join Date: Aug 2003
Posts: 12
Default

Hi, i just installed a msd 6a ignition and a ford billet distributor #8582. I saw the number 1 on the distributor cap it was right next to a outlet for a plug. So i used that for my number 1 firing wire in my firing sequence is this correct? It must wrong because i have hooked everything up correctly but the engine just turns over every time when it generally starts right up. And what type of type of wires should i get? I want 8.5 but i need to be sure they will fit my #8582 standard distributor cap.
Thanks For your Help!!
Reply With Quote
  #2  
Old 08-09-2003, 06:55 PM
msdtech1's Avatar
msdtech1 msdtech1 is offline
Senior Member
 
Join Date: Apr 2003
Posts: 761
Default

If you replaced an existing distributor then you should have made a mark where the rotor was pointing to and then installed the MSD Distributor so that its rotor was pointing in the same direction. If you did that then the position of the wires on your original distributor would be the same for the new distributor. If you did not mark where the rotor was pointing then you will need to rotate the engine over until number one cylinder is at top dead center on the compression stroke. Then look to see which terminal on the cap the rotor is pointing to. This is now where your number one spark plug wire should be attached to. The follow the firing order to put the rest of the wires on the cap. That's it. For the 8.5mm MSD Wires you will want to use PN 35399. That set will fit your distributor cap with spark plug style towers.

MSD Tech1
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Rma Number? giovannibianco Installation Questions 11 06-06-2006 03:41 PM
Part Number BrianR84 Applications 1 09-30-2005 10:22 AM
Blaster Coil Part Number 4573 MChat Applications 1 05-17-2005 10:24 AM
What Super Conductor Part Number For My Car? Blk88GT Applications 3 11-25-2003 11:56 AM
Part Number For 8.5" Super Conductor Plug Wires??? QTRPNDR Trouble-Shooting 1 11-03-2003 02:30 PM


All times are GMT -6. The time now is 10:20 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
2011 MSD Performance