powergrid and promag44

[sune]

Hi

I have a blown TFX hemi with a 44 promag and a 8147 box. I tried installing a powergrid to be able to 2 step the engine etc.

But When i try to run the engine with the powergird connected it is unable to run decently, it stumbles and rpm goes up and down. If I disconnect the powergrid the engine runs like normal.

Is it not possible to run an ignition like mine with the powergrid or what gives?

[msdtech1955]

check the general setting first.

reep general settings.jpg

reep main timing.jpg

reep1.jpg

[msdtech1955]

also make sure the black wire is grounded and the orange is connected to the battery...plus...the heads grounded...

powergrid to promag 2011.jpg

FLOATING GROUND1.JPG

[sune]

Thank you for a quick responds.

I forgot to mention i am running without a crank trigger. getting the signal directly from the promag44 generator.

Both the heads are grounded like the diagram.

And the settings seem correct.

Could it be because i run without a crank trigger?

[msdtech1955]

Could it be because i run without a crank trigger

it would work with just the generator also ...


using any retard?

[sune]

No retards yet, only the limters this was the first time we tried it, we had to disconnect it to just get it to run.

[sune]

So anyone got an idear what the problem is ?

[msdtech1955]

get your laptop up and ready and call us...


we need to see the files from the grid .

[sune]

There are no recordings on the sd card I just checked, Can i upload the user data somewhere? If at all posible i would like to sort this via mail as i live in Denmark

[sune]

Originally Posted by FooxNulp

I think, that you are not right. I am assured. Write to me in PM, we will talk.

email sent