MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Powersports Forums > Installation Questions

Installation Questions Wiring diagrams and tech notes for powersport applications

Reply
 
Thread Tools
  #1  
Old 07-12-2012, 03:04 PM
bigbadchevy89 bigbadchevy89 is offline
Junior Member
 
Join Date: Jul 2012
Posts: 6
Default 1969 evinrude 115

HI everyone I am looking to do an upgrade to a 1969 evinrude 115 which has an automotive type sensor pickup, coil, cdi box and distributor system on it stock. I would like to replace the stock cdi box which is bad with a msd 5520 I know this is a non marine unit but I can install in on the boat where there should be no chance of the unit seeing any water unless the boat goes down. What I am looking to do though is drop the voltage of the unit from 435 volts down to around the stock units 300 volts which will allow me to get the voltage going to my distributor around the 25000 to 3000 volts mark I need. Can anyone offer a suggested way of doing this. I was thinking a ballast resistor between the box and coil but I am not sure what resistor to use. The other thought I had was I have found some 73:1 coils that in theory would drop the voltage to max of around 32000k. Has anyone done this or can anyone offer some input?


Thank id advance:

D.C.
Reply With Quote
  #2  
Old 07-16-2012, 06:34 PM
bigbadchevy89 bigbadchevy89 is offline
Junior Member
 
Join Date: Jul 2012
Posts: 6
Default

Is there an msd tech out there with any input?
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 07:44 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
2011 MSD Performance