Wiring Diagram or Wire colors for this module ??

[PLF]

I searched the whole internet for info on this but with no luck..

There is no serial or modele number on it only a sticker with batch number, I looked everywhere on it and nothing...

I have this MSD Module in my Seadoo HX, it is the water injection module (correct me if not), my problem is that I think it is not wired correctly and prevents me from stopping the engine using the start/stop button, I have to remove the lanyard.

I have pretty much figured all the wiring but at a minimum I would like know the function of the white and pink wires (white seems to be rpm signal at least) but the pink I am not sure.

Thank you for your help !

Here is the module

[msdpowersports1]

From what I can see on the pictures it may be our old Sea Doo rev limiter part number 4258. Can you please email me the lot number that is on the unit to make sure I get you the correct instructions?

rcorral@msdpowersports.com

Thank you
Ray C.

[PLF]

Originally Posted by msdpowersports1

From what I can see on the pictures it may be our old Sea Doo rev limiter part number 4258. Can you please email me the lot number that is on the unit to make sure I get you the correct instructions?

rcorral@msdpowersports.com

Thank you
Ray C.

Here you go

Thanks

[the wayniac]

I've used that same ECWI controller, and I'm pretty sure the pink is the external safety lanyard wire. Pink would go to one side of the lanyard and the other side of lanyard to ground. I have one or two of them left in with my race stuff, but not installed. Just the same, i'd be happy to look.