Engine cutsout for flash then comes back

[garrity455]

I took it for a drive. The car doesn't idle as well without the msd, but it never did the cutout that it was doing before. I will try another drive tomorrow.

[garrity455]

I took it for another drive today. On the interstate this time, and it did not cutout at all.

I guess that means the coil is ok.

So I plan to wire the msd back in.

Out of all the wires, I assume the 12 volt igniton hot would be the most likely to cause this?

I intend to recheck all of the wires, but want to focus on the most likely.

Thanks,
Mike

[msdtech1955]

p/m a daytime phone number

[garrity455]

I am in meetings most of the day, but am free from 12:00 to 1:00 cst time.

My cell is 708-699-7979.

Thanks,
Mike

[garrity455]

Anything else guys?

[garrity455]

I wired the box back in this weekend. I went over the wires again, but the issue is back, I don't know what to check next.

[garrity455]

I did drill a hole in a cap and adjust rotor phasing for my 6al last year, would my phasing change with the digital 6 plus? Rather than a long ground wire to battery, should I run a short wire to the heads?

[garrity455]

Last night I used the ignition hot signal wire to signal a relay to run a wire from the battery through the relay for the signal wire. I will let you guys know if it solved it.