MSD Tech Support Forums

Go Back   MSD Tech Support Forums > MSD Ignition Forums > Trouble-Shooting

Trouble-Shooting Diagnose your ignition

Thread Tools
Old 09-27-2012, 11:12 AM
Posts: n/a
Default timing issue (locked dist)

My name is lance. Always used msd products and usually never had a problem.

Baiscally here is my set up.
Sbc big cam heads etc.. nice stout mot
Msd digital 6al. Blaster 2. Probillet ordered locked. And msd 8.5's

This should be 100% locked out timing. When I put a timing light on it says 40 degrees of timing and once I. Give it any form of increase in rpm the timing changes. ( goes to 32 when 40 is at idle) when the rpm's go back to idle it take a few seconds but will go back to the 40 degrees.

Cam to dist gear mesh is fine. Dist dosnt move. Timing chain is tight.
Can this be the digital 6 al problem? Makes no sence
Reply With Quote
Old 09-28-2012, 08:30 AM
msdtech1955's Avatar
msdtech1955 msdtech1955 is offline
Senior Member
Join Date: Jan 2008
Posts: 10,043

what i would do first....take the cap off ,so you can see the rotor.
with a breaker bar ...turn the motor back and forth to see how much "slack" in the chain is present.
Reply With Quote


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 02:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
2015 MSD Performance