MSD 6AL (6425) + 8910EIS on 3SGE 3rd GEN

[albjoa]

Hi ...

I'm trying to install an MSD 6AL (6425) with a tach adapter 8910EIS in a 3SGE 3RD generation engine ...

I install everything as shown in the diagram that comes with the 8910EIS, but the engine will not start ...

It was verified if for spark on the spark plugs, apparently is not injecting fuel ...

The motor works normal, everyday use, but I want to install the 6AL ...

I hope you can support me ...

Very grateful ...

[msdtech21]

Whats a 3SGE engine? What year, make, and model would this normally be found in?

[albjoa]

Thanks for your quick response...

The engine is an EFI 3SGE JDM Toyota Celica has ignition module and then connected everything as instructed in the 8910EIS tach adapter that is recommended for Toyota.

It has been verified and no spark at the spark plug but apparently lost the signal to the injectors, because the engine makes the attempt to start and off at 3 seconds.

Reading the manual states that some EFI systems do not work properly for the rev limiter, and I see the steps to disable it, does that help me?

My setup is as follows:

- Pn6425 6AL
- TACH ADAPTER pn8910EIS
- Blaster SS Coil pn8207

I hope this information can help you.

Sorry for my english, but I am using the google translator.

[albjoa]

in this thread is the solution to my problem ...

http://msd6al.com/forum/showthread.php?t=18250

[msdtech1955]

does yours look lie this?

celica 35ge.jpg