2001 dodge durango

Liquidoutl4w · #1 06-25-2012, 08:21 PM

Ok here's the situation. I'm looking to spend max of 70 per coil. (I need 8) what would you recommend for my 4.7L engine (I am removing the coil overs and relocating the coils via custom mounting bracket in the engine compartment and will run custom length wires to the plugs) I will be changing to 206 cams, hedman headers, magnaflow cat, flomaster muffler, stage 1 chip, k&n CAI, 2800 TC. Is there also an ignition module you would recommend that would bolt up to this engine? Thanks in advance!

msdtech1955 · #2 06-26-2012, 08:14 AM

still using the oem ecu to drive the coils?

Liquidoutl4w · #3 06-26-2012, 02:09 PM

Yes I was thinking about the 8207 can they be manually hard wired? Are those +,- posts on the side?

Liquidoutl4w · #4 07-07-2012, 07:53 PM

Hey any news on my question? The 8207 coils should work if I wire them in right?

msdtechsupport3 · #5 07-09-2012, 11:25 AM

Please keep in mind the primary resistance of the Blaster SS coils (PN 8207) is 0.35-ohms. It is unknown if the coil drivers in the ECM can work with this.