Tach adapter 8910 or 8910EIS

[not_mechanical]

Vehicle Suzuki Jimny, 4cylinder, F10A engine.
I have MSD6AL 8910EIS PN.6425 and Tach Adapter is ready to be installed.
But I still doubt the Tach adapter. Is it supposed to use 8910 or 8910EIS?

one more question:
If there are errors in the installation,
example:
HEAVY RED = OK
HEAVY BLACK = OK
RED = an error "This wire to conect to breaker points, electronic ignition output"
and
White = an error "Thus Spake wire to conect to a switch 12 volt source Such as the ignition key"

In these conditions, Does MSD will be damaged at the time?


Thanks,

[Gaz64]

In your above statement, the small red and white are wired backwards.

Small red is ignition switch 12v.

[not_mechanical]

Originally Posted by Gaz64

In your above statement, the small red and white are wired backwards.

Small red is ignition switch 12v.

Yes, I know ... the small red wire should be connected to the ignition switch 12v, but in this case the error is corrected after only a minute and try the ignition "on"
What is the effect of MSD, will it be broken?

Thanks,

[not_mechanical]

Originally Posted by not_mechanical

Vehicle Suzuki Jimny, 4cylinder, F10A engine.
I have MSD6AL 8910EIS PN.6425 and Tach Adapter is ready to be installed.
But I still doubt the Tach adapter. Is it supposed to use 8910 or 8910EIS?

What would happen if you do not use the tach adapeter, so just use MSD6AL?

MSD techs, any advice?


Thanks,

[msdtech1955]

8910eis ....on the suzuki's

[not_mechanical]

Originally Posted by msdtech1955

8910eis ....on the suzuki's

thanks for the advice.
So I will try to set it up.
If there is a problem, I beg you will help me again

[not_mechanical]

Before installing 6Al box and tach adapter, I want to ask about the wire in this picture:
Is it true that the wire from the A and B are connected like that?

[msdtech1955]

ya buddy !
kenny-powers-kswiss-viral.jpg

[not_mechanical]

Originally Posted by msdtech1955

8910eis ....on the suzuki's

Thanks for advice ....
the machine is working properly.
Let's run away ... go...go.... go....