|
|
#1
04-08-2012, 01:35 PM
|
|||
|
|||
7445 Adapt a cap dimensions
Are there engineered drawings for the 7445 adapt-a-cap kit? I've got a one off distributor drive that I want to change over to the 7445 cap and rotor kit. I know I need the cap, base, rotor, rotor adapter.
|
|
#2
04-09-2012, 07:06 AM
|
|||
|
|||
|
Measurements I need....
Base diameter On the distributor it adapts Shaft size/shape How much does the shaft Stickout from mounting flange
|
|
#3
04-09-2012, 04:12 PM
|
|||
|
|||
|
-I have an old MSD distributor with a black plastic Rynite base and a #7445 cap adapter set that measures:
1---1.580” cap adapter mount surface to top of rotor mount surface 2---2.757” cap adapter mount surface to top center of rotor’s flat contact spring surface. 3---0.714” mounting surface for cap at top of cap adapter to top or rotor’s flat spring. 4---0.623” caps center rotor button down to mounting surface for cap at top of cap adapter. 5---0.091” preload of the carbon button against the rotor’s flat center spring. -there is about .015" end play in the distributor that I wasn't paying attention to while getting these measurements. ------------------------------------------------------------------------------------------- -the bottom of the adapter base has recess where it slips down onto a distributor---the diameter of that recess is 3.780" and it's about .160" deep. -this adapter bolts down to a flat surface with either one pair of .630" wide bolt hole slots spaced at 4.330" or there's another pair of .630" wide slots spaced at 4.085". -rotor looks like it fits the older GM point style and MSD's fairly common old style Gm distributors where there is a square tab and a round tab on the rotor to orientate the rotor to the rotor mounting plate. Last edited by bill jones; 04-10-2012 at 09:00 PM.
|
 |
| Bookmarks |
| Thread Tools | |
|
|
