Need help with MSD quick connect

KJL Racing · #1 02-06-2010, 02:19 PM

I have an Accel BEI 35100 series distributor and would like to connect the MSD quick connect but problem is, this is not the typical 39000 series distributor and has an round four wire plug not a square four wire plug. I hope somebody will be able to help me how to wire this adaptor to use. Thank you.

msdtech22 · #2 02-08-2010, 08:08 AM

Hopefully, this drawing will be of assistance.

KJL Racing · #3 02-08-2010, 04:46 PM

Thank you for the diagram, it will be helpful. The question I have is that the #8802 connect has the input wire colors: red, white, gray, and green. The BEI has the wire colors: red, white, black, and green. Would you have any suggestions on direct wiring. This distributor is like new and I would like to use it with the benefits of an MSD module. Thank you again for the quick response.

msdtech22 · #4 02-09-2010, 07:36 AM

I would try and figure out that the red is power and the black is ground. After that, we are unsure.

KJL Racing · #5 02-09-2010, 06:24 PM

Thank you I do appreciate the help, that was my thinking also. I was sort of assuming color to color except the black and gray which may be ground. Thanks again if you might come across some info please let me know.

msdtech22 · #6 02-10-2010, 07:34 AM

Will try and assist as much as possible.