powergrid and promag44
 

Hi

I have a blown TFX hemi with a 44 promag and a 8147 box. I tried installing a powergrid to be able to 2 step the engine etc.

But When i try to run the engine with the powergird connected it is unable to run decently, it stumbles and rpm goes up and down. If I disconnect the powergrid the engine runs like normal.

Is it not possible to run an ignition like mine with the powergrid or what gives?

check the general setting first.

Attachment 2381

Attachment 2382

Attachment 2383

also make sure the black wire is grounded and the orange is connected to the battery...plus...the heads grounded...

Attachment 2385

Attachment 2386

Thank you for a quick responds.

I forgot to mention i am running without a crank trigger. getting the signal directly from the promag44 generator.

Both the heads are grounded like the diagram.

And the settings seem correct.

Could it be because i run without a crank trigger?

it would work with just the generator also ...


using any retard?

No retards yet, only the limters this was the first time we tried it, we had to disconnect it to just get it to run.

So anyone got an idear what the problem is ?

get your laptop up and ready and call us...


we need to see the files from the grid .

There are no recordings on the sd card I just checked, Can i upload the user data somewhere? If at all posible i would like to sort this via mail as i live in Denmark

email sent