View Full Version : Msd Soft Touch Rev Controler
I need some advise on connecting a MSD Soft Touch Rev control unit part 8728
while the original instructions are gone.
There are four wires : green, red, black and white.
Any idea as to where these wires must be connected ?
Your help is appreciated.
10-27-2003, 11:50 AM
Send me a message with your fax number or mailing address and I will send you the instructions. Please let me know what you are trying to install this unit on so I can get you the right instructions.
I am trying to install the rev control to a V8 engine with conventional
Mallory distributor and Luminition (photo cell) ignition/coil.
Do I connect this unit to the distributer or the coil ?
My email is firstname.lastname@example.org
fax 00 32 3 6676077
10-28-2003, 09:15 AM
I will get that faxed over!
Thanks MSD Tech4, your fax is well received !
Will start the connection acc fig 3 while my distributor is with optical trigger
so the white/green wires will be connected to neg (-) on the coil.
On the last page the RPM module kits and RPM module selector kits
are mentioned. Can I use the RPM module selector PN8671 on this unit ?
10-30-2003, 10:39 AM
Yes you sure can. Any of the RPM selector switches will be fine.
vBulletin® v3.8.7, Copyright ©2000-2015, vBulletin Solutions, Inc.