75314 Shift kill option

[fmunk]

Does anybody have expierience using the step3 wire and programming it for shift kill.
Is there anyway I could get more information on setting this up. I am hoping to control the amount of TIME the ign is killed, can this be done per gear?

The reason I ask per gear, the amount of time the engine would need to be interupted for the 1-2 shift is greater than the 3-4 and even a bit more than 2-3. So if all CUTS were the same amount of time, the 1-2 shift would be good but the 2-3 would be a bit to long, the 3-4 would be to long.

I am talking a clutchless trans.
Hope all this made sense!!

[msdtech4]

fmunk,

The way the kill function works is when you apply power it will shut the ignition down for ever what amount of time power is applied to the step wire with this function being turned on. You could actually use timers on this wire so it could kill the ignition for the specific time you wanted in each gear. This way first, second, third etc., can be delay specifically for that gear change.

Thanks,

MSD tech4