View Full Version : Module For Ready To Run Ford
10-10-2003, 12:19 PM
What ignition module is used in the #8354 Ford Ready to Run Dist? I don't see a replacement module for it in your catalog. Is there an O.E. or aftermarket module that could be used to replace it in the event of an un-timely failure?
10-10-2003, 03:43 PM
I hate to say it but unfortunately there is not a replacement module on that distributor. There is a fair amount of work involved in changing out that module including pressing the gear on and off and soldering on the board. this is something that will not be able to be done on the side of the road or in a typical garage. Unfortunately if that fails it will need to come into us to be repaired. In a pinch you could cut the magnetic pick up wires and route them outside the distributor to a separate module. If you would like a diagram on how to do this e-mail me a fax number and I will fax you a diagram. (firstname.lastname@example.org)
vBulletin® v3.8.7, Copyright ©2000-2015, vBulletin Solutions, Inc.