Car Will Not Start With New 6al

[crvtec]

1991 acura integra dist.

I just installed a 6al w/ blaster 2 coil and the car would not start then it did start and it ran fine for 1 day and now it will not start but it cranks over. I also have spark . The way i hooked it up is as follows

orange and black wire to coil positive and negative
Orange to pos coil
black to neg coil
red and white to inside of dist.
red to positive coil wirewhich is black/yellow in dist.
white to neg coil wire which is white/blue in dist.
thick red to batt. pos.
thick black to batt. neg

there is also a blue wire coming out of dist to a plug on back of dist. also a black/yellow wire going into same plug.

now the car will not start it just cranks over.

Please let m,e know of any ideas asap thanks

[msdtech1]

I take it that you are still using the factory coil that is inside the distributor. Your installation is correct based on the information you provided. Bypasss the MSD unit and return the wiring to stock to make sure that the factory ignition module or the coil did not fail. This will help you narrow down the search for the problem.

MSD Tech1