PDA

View Full Version : Pro-crimp Tool 3505


1961f100
09-25-2003, 03:38 PM
Will the pro crimp tool crimp 8mm wire from other manufacturers properly? Does it have strippers built into it?

msdtech1
09-25-2003, 05:07 PM
Yes, the PN 3505 Pro Crimper will crimp other terminals. As for the stripping process, it does include a stripping device but it will depend on the diameter of the conductor that the wire uses.

Jeff Gaul

1961f100
09-26-2003, 08:14 AM
I will be using pertronix flame thrower 8mm wires. Will they strip that fine?

msdtech1
09-26-2003, 10:14 PM
That is not a commonly used wire, so I do not have any info as to whether it will strip that wire or not. I can tell you that the stripping portion of our crimper has a 0.0125 hole. As long as the diameter of your wires core is smaller than that you should be ok.

MSD Tech1