PDA

View Full Version : installing a HVC ignition


Warren Motorsports
07-03-2003, 04:21 PM
I recently purchased a 6HVC ignition box off someone and I need to know how to get the ignition hooked up. Is there a harness that I can get to hook up to the 6 pin connector? This is going on a race aplication with no factory type wiring. if not I need a schematic on what wires to where. Also I was running a 6al box with a pair of crane LX1 coils. Will these coils work with the 6hvc box? Thanks for your help.

msdtech2
07-07-2003, 11:14 AM
There is a harness available, but if you could contact our customer service department, at 915-855-7123 they will be able to get you one. The instructions to this unit are also in our website, under downloads. It is a PN 6600. The Crane coil will work, but may not work to its full potential, the 6 HVC Ignition is strongly recommended to be used with the PN 8250 HVC Coil.
Thanks,
msdtech2

Warren Motorsports
07-11-2003, 08:27 PM
Thanks for the help. I bought the harness and the PN 8250 coil and what a difference at 9000 rmp..The coil is way better than the crane coils by a land slide....Thanks again

msdtech2
07-14-2003, 10:01 AM
No problem, glad to hear the good news.
msdtech2