PDA

View Full Version : another question


radzer0
09-08-2003, 10:03 PM
deicded on getting a 1.8l 91 acura integra

what can i use on it?

i saw you sell a distributer cap for it.. but list that part num also for me

msdtech1
09-08-2003, 11:46 PM
The MSD Digital SCI Ignition, PN 6350, MSD 8.5 Super Conductor Spark Plug Wires, PN 32329 and the MSD Modified Distributor Cap, PN 8290 (Black) or PN 82901 (Red) can be used on your Acura Integra 1.8L Engine. Here are a few links to information on the products I have listed.

SCI Digital Ignition Info
http://www.msdignition.com/sci_1.htm (http://www.msdignition.com/sci_4.htm)

MSD Modified Distributor Cap Info
http://www.msdignition.com/sci_8.htm
http://www.msdignition.com/sci_9.htm

8.5mm Super Conductor Spark Plug Wires
http://www.msdignition.com/wire_sets_1.htm

MSD Tech1

radzer0
09-09-2003, 08:36 AM
do you have a coil that will work on it?... or is it a internal distributer coil?
because i have seen alot of power gains with that

msdtech2
09-09-2003, 10:42 AM
The coil that will work well is the PN 8207 Blaster SS Coil, if you go with the modified cap this will allow for the external coil.
Thanks,
msdtech2

radzer0
09-09-2003, 10:48 AM
will the coil work without the msd box?
or would i need to get that first


also the dis-2 HO

is it race onlybecause it overheats?.. or whats the reason?

msdtech2
09-09-2003, 05:12 PM
I apologize the Ignition unit that was recommended is not the correct ignition for your application, the Dis-2 is for the distributorless ignitions, since yours has a distributor, you can use the Digital SCI, PN 6350. (Note: previous post corrected 10-11-03 by MSD Tech1) This unit has a built in launch limit, start retard and a single stage of retard for nitrous.
Here is the link to this unit,

http://www.msdignition.com/ignition_19.htm

The Blaster SS Coil, PN 8207 could be used as a stand-alone unit, but will require the PN 8290 Modified Cap.
Thanks,
msdtech2