View Full Version : msd 20
09-02-2003, 11:07 AM
Has any on had trouble with shearing roll pin on msd 20 I will only get about 5 passes and shear my roll pin on drive gear to cam. I replaced the oil pump the gears mesh just at 3/4 of the way up the gear. I machined out a collar for the mag so it fit tightly in the manifold. I dont get it.
Any help would be app.
09-02-2003, 01:32 PM
If all the mechanical parts as far as oil pump, cam and valve train were in good working order, I would recommend readjusting the generator so that the gear mesh is centered on the generator gear. The other would be to make sure the engine is not detonating; we have run into one instance where the engine was detonating and causing the roll pin to shear off.
vBulletin® v3.8.7, Copyright ©2000-2015, vBulletin Solutions, Inc.