PDA

View Full Version : Proper Wiring for 6AL to Distributer part #8366


3rdGenZ
08-24-2003, 09:47 AM
I am having issues with my ignition timing/setup. I bought this car with a 6AL box and a Billet Distributer part # 8366 already installed. I need to get some direction on this to see if it is wired correctly. Can you help? The car is a 91 Z28 TPI car.

msdtech1
08-24-2003, 10:26 AM
Are you using the MSD GM Dual Connector Coil Wiring Harness? http://www.msdignition.com/install_access_3.htm

MSD Tech1

3rdGenZ
08-24-2003, 01:42 PM
No. It doesnt look like any of the ones fron the link you posted have been used.

msdtech1
08-24-2003, 10:33 PM
Here is a link to the MSD Ignition wiring diagram for your application. All the wirinbg will be done at the coil, and you do not need to do anything with the distributor.

http://www.msdignition.com/pdf/pdf9.pdf

MSD Tech1

3rdGenZ
08-25-2003, 04:36 PM
Thanks, I will assume that using a blaster 2 coil in place of the GM coil will not change anything as far as wiring. Black to (-) and Orange to (+) on the top of the blaster 2 coil.

msdtech1
08-25-2003, 06:04 PM
That is correct. Orange to Coil (+) and Black to Coil (-).

MSD Tech1