12Lt and getting started

[glow]

Hi ! Here is my list I put together to get started. Only part I'm not sure about is the black sparkplug wire hold down at the mag , should I go with the large cap or go with the band clamp ? this is a non blown motor . This application is a L/H turn boat . Any suggestions? Did I miss something ? should I start with the larger cap and can I buy the larger cap when I order ? this will let me use the wire hold down I need for a boat application. Keep in mind I will need 3 caps , phase, use, backup . any ideas ? any initial set up information would be helpful . thanks G

12LT MAG # 7908 (1)
ELECTRONIC POINT BOX # 8106 (2)
VIBRATION MOUNT # 8823 (1) $
CAP AND ROTOR # 7909 (2) $
WIRES # 31579 (1) $
MAG COVER # 8166 (1) $
POINT BOX COVER # 8167 (1) $
SET UP TOOL # 8122 (1) $
DIST TOOL # 8599 (1) $
SPARK GUARD # 8804 (2) $
WIRE SEPERATOR # 8843 (1) $
COIL WIRE # 84039 (1) $
TIMING TAPE # 7926 (1) $

[msdtech21]

The PN 7909 and PN 8167 are obsolete parts. This seems to be a long duration race because of the l/h turn boat. I would rather go with an 8139. You can also update it to the 7455 6” Pro cap. That 8139 can always be updated to a 20 amp. If you need the 7908 due to room restraints, you can update to the larger cap# 7460.

Thanks,
MSDTECH21