Weight:

Logger only - 13oz
Entire G2X kit: 1lb 13oz (.81 kilo)

Memory:

128MB compact flash - up to 512 MB may be utilized
Approximately 25 hours of data (with no external sensors in use)

Automated Logging Process:

- Logging starts at 25 MPH (40 KPH) which may be changed by user
- Logging stops when no speed is detected for 30 seconds or greater
- Auto-writes consecutively numbered runfiles. Does not overwrite existing data
- Allows user to make multiple runs without downloading data

Internal Sensors:

- 100Hz Lateral and Longitudinal Accelerometers
- 4 Hz GPS board combines with 100Hz accelerometer data for mapping data
- Battery Voltage
- Engine RPM (with appropriate tach signal)

Power:

12-18VDC / 800-900Ma

Sensor Inputs:

12 total external Vnet sensors or gauges connected via the AUX Input
Vnet sensors may be analog, RPM or any combination of both
1 Display Dash Input
1 External Secondary RPM Input (wheelspeed or when utilizing GMR)
1 Power / Tach Input
1 EFI Input (See Vnet Sensor Page)
1 GPS Antenna Input
1 External Beacon Receiver Input

Engine RPM Signal requirement:

50% duty cycle, square wave tach output signal (aftermarket ignition box type)
If this type of signal is not available, utilize the Racepak GRM pickup

Exterior LED Displays:

2 GPS Satellite LED Indicators
1 Compact Flash Card LED Indicator
1 Power/Processor LED Indicator

GPS Antenna and Cable:

1” (25mm) x 1” (25mm) Size
Magnetic Base
SMA Connector